Overall height 3 1/4″Diff Cover
GM 1972 to 2013 K1500 Truck, Yukon, Suburban G10 &G20 2500LD, Blazer, & some cars
Vehicles with Coil Springs will need some fabrication to install
Includes: Bolt kit, Drain Plug and Dip Stick.
Capacity: 4 Quarts
Heavy Duty differential covers and transmission pans provide increased lubricant and cooling capacity for hard working recreational and service vehicles. Mag-Hytec covers and pans set your vehicle apart in both aesthetics and function - cast in A356-T6 aluminum and texture powder coated black with machined cooling fins. Magnetic drain plugs trap worn gear material promoting fluid integrity. Each unit is fitted with ARP 568 O-rings for superior sealing. All hardware is 303 stainless steel, in most applications no gasket or sealant is required, and all Mag-Hytec parts are covered by a lifetime limited warranty. Depend on Mag-Hytec when you're pulling a heavy load.
Avoid costly reapirs - Extend the life of your Vehicle - Expand oil Capacity - Runs Cooler, Lasts Longer
Average of double the fluid capacity
Ease of Service
The dipstick is knurled for quick removal, the flat is marked low/high to check lube level and a magnet, which acts as an open filter is in the lower end. The MS 7/8 - 14 THD port is large enough to use for filling.
The magnet-filled drain plug is the same MS port as the dipstick. Both the dipstick and drain are O-ring sealed.
The sending unit fitting is 1/8 pipe THD and shipped with a stainless pipe plug.
The calibration plug is centered on the serial number plate and approximates the stock cover fill plug for factory fluid level.
The O-ring is snapped into the inverted "V" groove for a positive seal without gasket or silicone.
Plugs, cap screws and washers are stainless steel in most applications.
Mag-Hytec manufactures the best covers and pans available today.
|Dimensions||11 x 11 x 3.5 in|
|1/2, 3/4, or 1 Ton or Higher||
1 Ton or Higher, 1/2, 3/4
|4X2 / 4X4||
|Auto / Stick||
|Diesel / Gas||
|Truck, Van, Motorhome||
Motorhome, Truck, Van